The Wall Panel CP8 is designed to be able to remote control the Marani DPA880T and DPA880AMT via the RS485. The panel is designed using a standard Clipsal 2000 plate however the mounting has to be adjusted because of the circuit board located on the rear of the panel.

The CP8 recalls up to 6 assigned presets that have been programmed and store. The selected preset LED light will flash until the preset is loaded within the DPA880T and DPA880AMT and then stay illuminated.

A master volume control increases and decreases the master volume. The volume master control ramps up and down by either holding the button or by presses. The LED will illuminate while the button is pressed. The volume ramps slowly at 1dB increments so quick changes are not possible by mistake.

A Key Switch enables you to lock the panel once the preset and volume have been assigned.

Product Features

• Recalls up to 6 programmed presets
• LCD front panel screen
• Master mode and Zone mode operations
• Control any Input or Output volume or mute
• Master volume up and down control
• Multiple CP8’s can be connected to one DPA880T on the same ID
• Gray front plate
• Connection cable use CAT5
• Power supply 12v DC required (not included)
• Suitable for use DPA880T
• NOTE: Existing DPA880T software needs upgrade to drive the CP8

Technical Specifications

Power Connector	12V DC Screw Terminal
Input Connector:	RS485 Screw Terminal
Net Weight:	.8Kg
Gross Weight:	1Kg
Dimensions (W x D x H):	90 x 53 x 170mm
Packaging Dimensions 1pcs/pack: (W x D x H)	90 x 53 x 170mm